Crown SC4000:
Code 35

Cannot find any information on this code can anyone help??
  • Posted 16 Apr 2016 07:43
  • Discussion started by JAYS
  • Iowa, United States
Showing items 1 - 1 of 1 results.
Code 35 is master controller not talking to slave controller. If it is new controller it needs programmed to be a master or slave depending what position it is in. If old master controller may have been reset by voltage spike and just needs reset or one or both controllers will need replaced.
  • Posted 17 Apr 2016 18:57
  • Reply by popeye
  • Ohio, United States

Having trouble using the Discussion Forums? Contact us for help.

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Global Industry News
edition #1130 - 1 June 2023
You might notice a few changes in your newsletter and on our website. That’s because we updated the format last week to make it even easier to read – and to... Continue reading
Global Industry News
edition #1130 - 1 June 2023
You might notice a few changes in your newsletter and on our website. That’s because we updated the format last week to make it even easier to read – and to... Continue reading
Fact of the week
Lincoln was known to have more than one stovepipe hat, each typically seven or eight inches tall. It is said that hats were important to Lincoln: They protected him against inclement weather, served as storage bins for important papers he stuck inside their lining, and further accentuated his great height advantage over other men.