I have a TCM w/ a K25L, just over 2200 hrs. Sporadically i get codes for the acc pot and throttle motor. using the Hitachi hand set i can watch the ETC sensor 2 spike voltage up to almost 4 volts when it malfunctions and MIL sets, idle is all over (hi/lo).
According to schematics ETC has six wires that go to large plug on ECM, and six from APS to small plug on ECM. I have tested all 12 wires from part to ECM they are all good. Grounds test good. I have replaced; ECM, APS pot, ETC motor, ETC relay. What am I missing? When it works it runs fine, there is no common event that sets code (ie; hot-cold-humid-dry etc)
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.