Showing items 1 - 15 of 15 results.
it can a lot of reasons for this errors, diagnostic with pc software really need
hello my trolley still R70-30 has the same problem it starts but does not want to move can you help me thank you
[email address removed]
hello my trolley still R70-30 has the same problem it starts but does not want to move can you help me thank you
[email address removed]
HI nacsand_n
Thank you very much.
204/196 - pump motor brushes are worn
Regards
HI everyone.
I need help. Its show code. Moter Brushes 204, and 196.
What does it mean.
HI nacsand_n
Thank you very much.
Brush are worn, check brushes or brush wear indicator inside motors.
Fisrt check fuse F6 in rear relay plate and also can check continuity between white and grey wires in four way connectors located on motors.
Regards
HI nacsand_n
I find the new CODE. It ERROR CODE 203.
What does it mean. please help me.
HI nacsand_n
I find the new Problem. The car's running slowly. Both forward and backward. Sometimes It will show error CODE 206,207,208,209
You will have a guide or something. Please help me.
If the gap of toothed gear is Ok, possible bad steering angle sensors inside console. Must replace console.
Also you can check and adjust the error tolerance of steer angle sensors through service address 13e.
01 (small tolerance)
02 (default value)
.
.
05 (large tolerance)
Regards
Hi nacsand_n
Thanks for the help. Today I had to check it. Now 208 , 209 is ok
but 119 is not clear. I check the distance between Toothed wheel and Console. However, it does not work. Do you have a solution.
Please help me again.
Ok,
Error 119 indicates a problem in the steer angle transmiters signals. First should check the toothed wheel under steering wheel, the gap between toothed wheel and console must be 1mm.
Angle sensor are inside console.
Regards
THANK YOU nacsand_n
There is one code is 119, not 109. Please help me.
208= fault in revolution sensor in right motor
209= fault in revolution sensor in left motor
Is not usual both motors fail, check connections, but It's possible needs adjust the distance between toothed brake discs
109= CAN fault. Usuallly appears when any outlets for additional consumers (lights, buzzer, etc..) is not well programmed.
Regards
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.