Crown 35SCTT:
main lift cylinder will not lift

I hope I can get advice from some experts. I have a Crown Lift that when you operate the controls for the main cylinder lift nothing happens. I found two switches one is set to normally open and the second to normally closed. I guess they are for the speed of the lift. All fuses I can find look good. Any trouble shootings steps I can take to troubleshoot?
  • Posted 18 Feb 2023 01:10
  • Discussion started by RickPeaches
  • North Carolina, United States
Showing items 1 - 2 of 2 results.
It is a possibility for the low battery. I just received it and the charger is not hooked up yet. I will give that a try thank you.
  • Posted 19 Feb 2023 08:16
  • Reply by RickPeaches
  • North Carolina, United States
you sure the truck is not in lift interrupe if the battery is weak or very low it will not allow you to lift l would look at that first try to charge the battery and than see if it lifts you might be chasing a problem that is not there. If that does not fix it try look at the hyd contactor see if you can manually push it in to see if the hyd motor turns on it is possible you have a bad motor
You also could put a meter on the two cables at the motor and pull the hyd handle to lift and see if you have battery voltage to the motor. Also check the switches that you talk about in your post that is what signals the contactor to close make sure that when you pull the hyd handle that the switch is closing l seen them come out of adjustment and not close. Hope l was of some help.
  • Posted 19 Feb 2023 07:20
  • Reply by Scott_
  • Pennsylvania, United States
Scott

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.

Upcoming in the editorial calendar
Upcoming industry events …
May 09-11, 2025 - Bangalore, India
October 21-23, 2025 - Panama City, Panama
July 15-17, 2025 - Hong Kong, Hong Kong