units dash display code t/m controller k.o - Technical Troubleshooting discussion in Forkliftaction's forums

Clark C70D:
units dash display code t/m controller k.o

not sure if this is a code or a readiness monitor. if it is a code where do i begin? i do not have software for this truck.

Posted 8 Oct 2021 01:07
Discussion started by James_Terry
Iowa, United States

james terry

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

Did you ever figure out what was wrong with this. I have one that is giving me a spn:100B /FMI:2 shut down truck controller can KO. And I get this as I turn on the key. About 20 seconds after

Posted 2 Oct 2024 06:52
Reply by James_Binder
New York, United States

Post a Reply Report this post

That's a fault code.
The transmission controller isn't communicating properly with the dash.
Start with wiring connections and check all chassis grounds.

Posted 14 Oct 2021 23:42
Reply by kelsey
Tennessee, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.