1. Home
2. Forums
3. Technical Troubleshooting
4. Crown
5. RM6025-45

Crown RM6025-45:
Event code 226

The forks goes up very slow and also it goes down very slow.
The lift pump motor rotates very slow on both directions.
the 3 phase cables from access 2 to pump motor heating up.
What could be the possible cause?

• Posted 4 Feb 2021 07:17
• Modified 9 Feb 2021 22:10 by poster
• Discussion started by RamKhudan
• Netherlands Antilles

Ram
ramkhudan@gmail.com

Post a ReplyReport this post

I checked cooling fan, the fan run good
I checked all the connections, all good

• Posted 6 Feb 2021 06:16
• Reply by RamKhudan
• Netherlands Antilles

Ram
ramkhudan@gmail.com

Post a Reply Report this post

I checked the battery condition
All are good, voltage are good under load

• Posted 6 Feb 2021 06:11
• Reply by RamKhudan
• Netherlands Antilles

Ram
ramkhudan@gmail.com

Post a Reply Report this post

Check battery condition, water level, and voltage under load

• Posted 5 Feb 2021 06:41
• Reply by Triggs
• California, United States

Post a Reply Report this post

the lift going up and down very slow
also the lift pump motor rotating very slow
the 3 cables to the pump getting hot
access 2 heats up and the code 226 sets, after lifting the fork for a minute or 2

• Posted 5 Feb 2021 03:46
• Reply by RamKhudan
• Netherlands Antilles

Ram
ramkhudan@gmail.com

Post a Reply Report this post

could be cooling fan not running, or loose connections building heat. you can check fan operation in accessories menu

• Posted 5 Feb 2021 03:19
• Reply by JMC1
• Iowa, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.