Showing items 1 - 7 of 7 results.
No it feeds the o2 sensor and the fuel injectors and the coil.
will give it a go tomorrow and will let you know what i find ? do you know if that would feed the ecu? thanks
Should not cause a problem for testing.
thank you can i run a wire from pos to d pin at coil? would this cause problems and have you done that before to help find problem?
Diagram shows 12v from fuel run relay connects directly to D terminal. May have a harness issue. Wire 751 also powers the O2 sensor.
Thank you checked c is ground d no voltage checked fuel run at pdm both upper have 12 v pos not sure where to go next also went to 6 pin and could not find 12 v ?
If this has four wires at coil pack. Diagram shows terminals A B C D. A and B are the triggers from the ECU. C is ground. D Should be battery positive with key on. Up stream there should be a 6 pin connector. There are two 3300 ohm resistors that receive a 5 volt signal from the ECU the come out to the AB wires on the coil pack. The battery positive feed comes from the fuel/run relay in the PDM.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.