Leaking Wheel Motor - Technical Troubleshooting discussion in Forkliftaction's forums

Linde (& Baker) H80D:
Leaking Wheel Motor

Hi,

Just after some advice on a leaking wheel motor, I have a H80D serial number prefix of H2X353T that has a leaking sealon the drive wheel end. I have taken the mast off and I'm removing the ring of allen bolts. Can we then remove this reduction hub to have the seal replaced? I know there is a castleated nut which is torqured to about 3000nm. I will probably get this sealed by another compant If I can find one.

Thanks Kenco

Posted 17 Oct 2018 00:44
Discussion started by Coops
Kent, United Kingdom

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

You will need a special socket that is only available from Linde. I think it cost around $400.00.
You didn't need to remove the mast though. The tough part of the job is removing and retorquing the nut. You will need a big torque multiplier.

Posted 21 Oct 2018 23:06
Reply by duodeluxe
United States

duodeluxe

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.