Showing items 1 - 7 of 7 results.
Anyone have any luck sorting this? I have the same problem with my H8.0Ft6 with ku ota v3800t diesel engine
did you ever figure out what was causing this code?
Hi mate, just wondering if you had any luck resolving this issue? I've got the same model with the same fault. CAN lines/termination resistors are all ok. I'm suspicious of the engine ECU due to a few suspect readings it's giving.
please check fuses ign 1,2,3 in the PDM or fuse box this is located under the floor plate. there is a diagnostic port on the steering colum with mulitmeter on resistance scale check between 3 wires you should get about 60 ohms if you get 120 ohms you have a problem
CAN = Controller Area Network
CAN CONNECTED is the status of the CAN or that a network device/node is connected or not connected.
Generally this would be accompanied with a message like CAN CONNECTED HI or CAN CONNECTED LOW (something like this)
hi I am tech working on this unit what is CAN CONNECTED ?
DTC 2000-31 - CAN Tx Failure
DTC 2000-31 - CAN Rx Failure
A. TERMINATION RESISTOR(S) OPEN CIRCUIT
B. OPEN/INTERMITTENT CIRCUIT ON CAN HI, CAN LO
C. CAN HI AND CAN LO SHORTED TOGETHER
D. OPEN CIRCUIT ON POWER/GROUND TO CAN CONNECTED DEVICES
E. STG ON CAN HI
F. STS/STB ON CAN LO
G. CAN CONNECTED DEVICE FAILURE
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.