Fault code and limp mode. Discussion about troubleshooting Hyster

Hyster H210HD:
Fault code and limp mode

Wondering If I can get some help or a push in the right direction. The lift is showing a E0132 fault code on the display and its showing the dashboard light that looks like an bulb/flask with a spool or wire and an exclamation mark. The lift turns on but it's in limp mode. Pressing the accelerator does nothing. This happened after a leak under the cab. The hydraulic leak has been repaired. Since this error has started I have noticed it allows me to crank the engine and start it even if the parking brake is not engaged. I appreciate any assistance you may be able to privide.

Posted 12 Jul 2018 03:42
Discussion started by Rikoku
California, United States

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

Thank you, found the issue. The connector plug for the accelator was loose.

Posted 12 Jul 2018 06:41
Reply by Rikoku
California, United States

Post a Reply Report this post

Accelerator Pedal or Lever Position Sensor 1 Circuit - Voltage Below
Normal or Shorted to Low Source.

Posted 12 Jul 2018 05:59
Reply by BREWSKI
Nebraska, United States

Post a Reply Report this post

Having trouble using the Discussion Forums? Contact us for help.

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.