CAT GC25K Runs Rich- No Throttle Response - Design & Engineering discussion in Forkliftaction's forums

Discussion:
CAT GC25K Runs Rich- No Throttle Response

Hello,
I checked out the previous reports on this site for no throttle response. Has any one had problems with the electronic throttle and converter???? Do you need a analyzer to set the controls ???? If so do i have to contact the dealer.???? The unit runs great at the start but then starts to smell and have no throttle response. would it be easier to install a simple cable throttle and impco conversion kit. Looking for some advice.....good or bad....this unit is making my hair thin and gray.
Thanks

Posted 2 Aug 2008 00:55
Discussion started by Prentice
Ontario, Canada

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

you need the SG15 laptop kit
the ECM is a little black box next the battery below the right side support for the overhead guard?

i had one do the same exact thing about 2 months ago
(mitsu FG18K) same system
thats an emissions compliant model
here in the US reverting it would break some laws
idk about up there

after watching it on the laptop i swapped the ECM and it cleared the issue
but then it was breaking up under load occasionally
i went to go look at it but it ran fine for me (figures)
i didnt get back to solve that b4 i quit though and the guy is too far to realistically service him on my own

Posted 8 Aug 2008 07:50
Modified 8 Aug 2008 07:51 by poster
Reply by justinm
New York, United States

New York, New York its a heluva town..you know that The Bronx is up..and I'm Brooklyn down

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.