Hyster N40XMR fault code - Design & Engineering discussion in Forkliftaction's forums

Discussion:
Hyster N40XMR fault code

I wish to know what does mean the fault code 282. Can anybody help me? Thanks

Posted 12 Jun 2008 00:48
Discussion started by luis_y
Lima, Peru

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

do you know the serial number?
where are you reading this code from? the MIB board under the covers?

im assuming you see this code when you are not stepping on the pedal

a code XX82 read on the MIB
the truck model is not programmed into the MIB
did you mess withthe MIB at all?

code 82 is when you turn on the key and MIB function "01" has a value of 00

to set function "01" refer to the following table
all for a N40XMR
24v - symbol A = function value "48"
24v - symbol B = function value "49"
36v - symbol A = function value "50"
36v - symbol B = function value "51"
24v - symbol E = function value "78"
24v - symbol F = function value "79"
36v - symbol E = function value "80"
36v - symbol F = function value "81"

legend for symbols
A) OMNITROL with lift tilt and reach only
B) OMNITROL with lift tilt reach and sideshift
E) SEPARATE LEVER with lift tilt and reach only
F) SEPARATE LEVER with lift tilt reach and sideshift

OMNITROL is the controller on the right side with all hydraulic controls operated with your thumb
SEPARATE LEVER is self explanatory

Posted 15 Jun 2008 09:58
Reply by justinm
New York, United States

New York, New York its a heluva town..you know that The Bronx is up..and I'm Brooklyn down

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.