Hi i have a problem with a bt 0p hse 1000 ser no 550095aa.
Code 7 is flashing on the controller, dead man not working brake so no drive, cab,forks & steering working battery charged but in poor condition. How do you check out dead man switches i have no manual for this order picker.No isle sensors fitted.
Thanks.
Showing items 1 - 15 of 15 results.
Why? The potentiometer is okay.
Hi try un plugging the connection on the steer motor potentiometer
Hello,
I also have error 7 but the steering is working and the battery has 50 V (?!). Any suggestions?
Also, how to check errors on the A3?
Thanks!
ok i wll begin to test the cables. thanks a lot
HI JUST TO LET YOU KNOW THE ERROR CODE 7 WAS DOWN TO THE BATTERY. FITTED NEW BATTERY ALL OK NOW.
THANKS.
a tecnicians tell me few weeks ago that can be the orange baecon light. I try to disconnect it but the error is also present.
thanks
I M READING FROM LABEL
BT OPAL OM
MATR 291332
NO 291332AA/1996
Have you got the correct model ?
during the lift up or lift down few times display error C 025 and also few times rarely error C 125.
more and more often lately appears even if the forklift is not still running but i switched on error c016
SomeOne can tell me what i this errors.Thanks Robert
Hi done a sg check on the battery and found 3 cells dead and at 0v and 1.5 so it looks like the battery is worn out getting another BT next week so i will try it, but i think the battery has had it's day.
Is there's another truck on site plug that battery in, Check the A3 error first
The pot should not be to stiff but you need a good battery for this error
Ok thanks for the info i will check it out,the battery is in a poor state
1 cell shorted out and it is out of the truck,But would this stop the dead man working.
The pot on the steering gear chain is stiff is this normal?
error 7 the steering servo A3 is giving an error signal
see error code on A3.
I had the same fault before and it was down to a flat/bad battery
Hi has no one seen this model before? it has 2 dead man handle system you have to hold to take the magnetic brake off and then you get drive. The dead man must be some sort of proxy switch.
Thanks for any help you can give.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.