Showing items 1 - 9 of 9 results.
Hi there,
I am looking for the engine electrical schematic for my 2P5000 CAT forklift. If you have one, are you able to send it to me?
hello I need the electrical diagram of this forklift gives many errors P04, F04 E 21 E22 and more from now thank you very much
r o q u e c a r d a n @ g m a i l. c o m
boatsdoneright
i can tell you with fairly good confidence that you probably do have a break in a wire and the break generally is in the harness right at the sensor plug.
In mcfa's almighty wisdom they elected to change their wiring harness material to a more solid core (less strands) in their wires which in turn made them stiff and more brittle. They cannot stand much vibration. Over time the wires will break usually at where they bend. (in almost every case at the connector).
If you pull on the wires (one at a time) at the air flow sensor plug you will more than likely find one that is broken, it will stretch or pull out.
You can repair this (if there is enough wire) by soldering them back together.
I've done this many times. ;o)
This goes for any sensor that errors out, first rule of thumb is to check the harness for broken wires by pulling on the wires at the respective connector. If a wire is broken it will pull apart at the break.
do you have wiring diagram can you send it to my email ?
may you email this wiring diagram to me also? Thanks
f a c u n a _mx at h o t ma i l c om
could you email this wiring diagram to me also? Thanks!
I just updated it with my email.
Do you have an email to put in your profile?
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.