Showing items 1 - 3 of 3 results.
Lurching is not a good thing, I am going out on a limb and say the drive motor brushes are stuck in the holder or brushes have no spring tension due to being worn out. If it has been lurching long time then a possible commutator stone my temporarily fix or even fix the arched out bars. The unit will run with a brush missing from holder and that is where you do your dressing from. Let us know what you find.
It is a Nissan PO1 electric and the code is 524 TC-sensor had the same problem before and swaped the fuses on the bus bar and it ran for a while then started luching and now nothing at all,tried swapping again but did not work. Any thoughts would be greatly appreciated.
any codes?? might be throttle pot
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.