Doosan (& Daewoo) GC25E-3:
HEEELLLLLLLPPPPPPPPPPPP!!!!!!!!!!!!!!

Ongoing isues with GC25E-3. Did Head job in February. 15 days later: Coil pack, temp sensor, cooling sensor and wire repairs due to complaint of suddenly stoips while driving. May -Engine light, smells bad, idles but no drive power. Even sent a video of it. Replace Vaporizer, MAP sensor, fuel filter, carb kit. Running good. Now July same complaint, Smells like eggs and no power. I have never been able to duplicate problem this whole time, but have found other issues. Replaced Throttle Pot and Throttlebody due to runnning sluggish and delay between throttle application and RPM climb. Engine light still comes on mid RPM. I am lost! Any ideas would be greatly appreciated.
  • Posted 27 Jul 2013 03:44
  • Discussion started by RJN8
  • California, United States
Showing items 1 - 1 of 1 results.
Turn key on, depress accelerator full stroke 3 times in less than 5 seconds and then watch the check light and read off the code(s) stored in the SECM. Codes are 3 digits except Code 12 which means end of codes and it will then repeat from beginning. Post codes here. Also is this the Hyundai or GM engine?
  • Posted 9 Aug 2013 21:06
  • Reply by techno_nz
  • Canterbury, New Zealand

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.

Fact of the week
On average, people read 10-30% slower from a screen than from paper.