Showing items 1 - 3 of 3 results.
Thanks Ed. I'll start another thread with my problem
Does the code come up on the dash display or with the hand set tester? When using the hand set, always keep the setting control **** fully clockwise or you will get brush wear codes. They will also remain in fault code memory.
Do these ERC060's not have GE SX controlers?
Today I had a ERC050 with a code #41 which is drive circuit overheating but I'm not sure if it is the armature overheating or the controller overheating. Does anyone know if there is a thermistor in the drive motor? Mike?
If your truck has the SR/SP controller, the code is "Brush wear, lift pump motor"
If your truck is an EV100 powered unit, it should simply be an internal status code that means nothing.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.