Fu3 blows Immediately - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
Fu3 blows Immediately

Crown RC 5500

Arrived on site yesterday unit died pulling out of loading dock no power. replaced fu3 unit ran good beat on it hard for 20 mins returned to service. Called back out today same issue pulling out of loading dock unit died has no power went to replace fuse and it blew the second I turned key switch on. Operators manual doesn't show diagrams for pdi anyone have ideas where to look for shorts or what components to check.

Posted 8 Aug 2024 01:22
By Brennon_Skelton
joined 8 Aug'24 - 1 message
Minnesota, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Fu3 protects the key switch and everything past it. It is possible that the K1 or K2 relay has a short in it causing it to blow right away. The next part in the circuit is the brake switch and accessory switches. Make sure to turn them off and release the brake to eliminate those as causes. Otherwise TP8, 9, 3, and 4 are good point to test if there is a short on the distribution board.

Posted 23 Aug 2024 01:16
By DyslexicNerd_01
joined 13 Jun'23 - 218 messages
Wisconsin, United States

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.