stuck in creep mode - Technical Troubleshooting discussion in Forkliftaction's forums

Raymond 102XM:
stuck in creep mode

Hey guys. Gotta go on a service call tomorrow for a 102 stuck in creep mode. Researched the manual but didn't really find anything. Any thoughts?

Posted 12 Jun 2012 08:54
Discussion started by TBG3
Missouri, United States

Post a Reply Report this post

Showing items 1 - 3 of 3 results.

Sort messages by:

please post results!

Posted 28 Aug 2012 11:11
Modified 28 Aug 2012 11:11 by poster
Reply by derrick_r
Utah, United States

Post a Reply Report this post

handle adjustment, two possession handle making travel slow when the handle is at < 25% if adjusted correctly!

Truck configured for slow acceleration Check truck configuration.
Battery problems Replace battery with fully-charged good
battery.
Binding drive wheel assembly/drive
motor
Jack and block truck. Check that drive wheel spins freely. If
not, repair or replace.
Binding brake disc Check "Air Gap Adjustment"
Bad drive motor
(may test OK with no load, but fail
under load) or worn brushes
Repair or replace drive motor or brushes

Posted 28 Aug 2012 11:09
Modified 28 Aug 2012 11:10 by poster
Reply by derrick_r
Utah, United States

Post a Reply Report this post

brake adjustment
rabit button does not work
depending on the serial # it may have a bad contactor
wiring harness in the handle
belly button damaged

Posted 12 Jun 2012 09:36
Reply by JonG
United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.