I have a Komatsu FG25T-14, serial #587119A, LP lift. Had a Springer tech out to look at it a couple months ago, and he said my pedal position sensor was going bad. He made some adjustments and said maybe that will get you through ill have one sent to you and you can just put it on it is no problem. So put it on today, and now the lift will not rev up at all without coding out. Reset the code, and try again when it will rev up for longer than a few seconds it will rev up then down then up then down. Read in a different question about learning the system by turning on key for 5 seconds then off for 10 then back on for 5 and back off for 10. Made no change in how the lift was acting. Unhooked battery for and hr, made no change. Any advice on something else to check or maybe adjust to get this lift running without having to get a tech back out. Might I add that 2 have been and lift still doesn't run correctly. Thanks for you guys time.