Good morning, I've got a Yale NDR030EA swing reach with a lift cut out issue I'm trying to solve. The lift handle went out, I replaced it and got the unit up and running again but now when the carriage is raised above 3-4 feet the lift function slows. Travel is fine no effect to it but the raise and lower is slow until the carriage goes below 3-4 feet. I can lower it all the way down and everything resets too normal until the carriage is raised again then the cycle repeats. Does anyone know what causes this? could it be calibration of the height needs learning?
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.