20.60 S Pressure feed-back line is indicating there is no
system pressure present, allthough pressure should
be there
Controller reverts to a "shut down" mode and will force neutral
0
Stop machine & Contact maintenance for troubleshooting The analog input ANI0 is in the 1500 - 4000 ohm
range, while it should be in the 500 - 1500 ohm
range
Check the wiring between the controller and the pressure feedback sensor. Check
the pressure feedback sensor (engine running / stopped).
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.