Ok got a bit of an issue could use some help. Machine was pulling e-35 and shutting down after start up, troubleshot found ecm issue as this model has injecter driver built into ecm. the problem is solved BUT now you have to hit the accelerator to start the machine and the idle is super low? it will actually stall sometimes when switching from forward to reverse. I have no MIL and no warnings whatsoever on dash. I checked to make sure MIL is working by disconnecting a coil and it immediately lit until I reset it. Is there a relearn or something I should be doing and what tools would I need to do it?
Thanks guys I hope I explained the issue well