Just thought I would check back in and thank for the help again and let yall know what the problems turned out to be. The wires of the condenser and coil wire were shorted out. After I got fire back to the plugs it still would not start. I sprayed some carb. cleaner in the air intake and got it to start and run shortly but it would not stay running but a second or two. Luck have it, one of my customers ace mechanics came to pick up a welding job I finished for them and he took a peek at it. He determined that initially I had a bad coil and fixed that problem when I replaced the coil but when I changed the points the wire connectors were connected on the wrong side of the insulator. The reason it did not want to start was because it was kind of cold that morning. He said the rubber diaphragm in the carburetor is very old and is getting hard and loosing its flex especially in colder weather and its getting worse as time goes by. He said until I replace the diaphragm I can use a light bulb or electric heater to warm up the carburetor diaphragm and it should crank right up. So far he is correct