1. Home
  2. Forums
  3. Report post

Report this forum post

Fork lift was moved from a different location to ours with no records. OK to the issue. I was having a no start problem. there was a fuse bad. operated good for 1 week then a no start occurred. Traced that to the BRAKE SAFETY SWITCH. replaced that. no it starts but will not go in drive or reverse. hydraulics are working and there were no issues with the brakes or drive before it went down for the BRAKE SAFETY SWITCH. now stuck on where to go forward with.
thank you
  • Posted 14 Jun 2018 04:32
  • By JasonWC
  • joined 14 Jun'18 - 4 messages
  • Minnesota, United States

This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.

Indicates mandatory field
Your Focus
Carlos Mendes
Custom or standard? Choosing the right relay for the job
Carlos Mendes
Read blog
From the forum discussions …
"Toyota 8FGCU30 - thanks to several Techs- Also check the diaphragm in the mixer, have seen a lot that stick and cause the same issue"
John_Bradley, United States
Read & Post in our Forums
Machinery-onQ
Machinery-onQ.com is the one place to source and sell all your new and used machinery.
Find equipment for sale | Add a listing
VISIT
machinery-onQ.com
Machinery-onQ
From the forum discussions …
"Unicarriers - it would have to be for a dual fuel unit also. Usually a bad cam or crankshaft sensor will throw a E-27 or a E-28 code on the dash panel... If it does not light up and the bulb is bad then it will not start also."
mwjago, United States
Read & Post in our Forums

Showcased in the Virtual Expo

Fact of the week
Sourdough bread contains Lactobacillus reuteri, a probiotic bacteria. During pregnancy and breastfeeding, these bacteria can travel from the mother's colon to her breast tissue and be passed to the infant through breast milk. It offers various health benefits, including potential protection against breast cancer.

Showcased in the Virtual Expo

From the forum discussions …
"Toyota 8FGCU30 - thanks to several Techs- Also check the diaphragm in the mixer, have seen a lot that stick and cause the same issue"
John_Bradley, United States
Read & Post in our Forums
Movers & Shakers
Jeannette Walker Jeannette Walker
Jeannette Walker
CEO, MHEDA
Stéphane Hénon
President, European Rental Association (ERA)
Tejal Ranjan
Chief marketing officer, JLT Mobile Computers
Pete Stanislawczyk
Chief executive officer, East Penn Manufacturing