Ser;easi-95-ab11633
No fault code when turning the steering over orange bar brake are apply.steer encoder test ok and proximity switch.any ideas
Showing items 1 - 6 of 6 results.
If you hear the clunk then you have a steer/brake issue, not a mechanical binding issue. When you state that the electrical components tested OK is this through the lift or with seperate test equipment?
Have you relearned the speed as well?
Raymond alos updated this steer gear box to a "straight" style gear reduction as opposed to the offset style.They had issues with the retaining bolt shearing and the base plate on the gear box cracking.
If its a steering isuue sometimes the pinion binds on the steer assy. and only with the tire on the floor, and you will get a steer prox or steer encoder fault when both test good.
Normally the brake wires break or twist in the harness just above the motor, or right where they enter the brake head.
same thing whit truck jacked.i did relearned, wire ok i hear the brake `clunk` whit the brake apply i still have throtle responce.
With the truck jacked up does this happen?
Is the steering relearned?
Are the brake wires worn away or shorted together?
Do you hear the brake 'clunk' on or doe sit just not move?
Just a few places to look and start
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.