Back story, this unit had a bad converter seal and leaking front pump seal. Removed engine, replaced seals, and re-install engine. Now, I cannot get the unit to idle, as well as hard starting. Will run great when pedal is fully depressed, or anywhere between 1/4 throttle to full throttle, however when pedal is released, unit stalls out. Replaced accelerator pedal (electronic) combed over every inch of engine to make sure I didn't miss anything. Any ideas?? After unhooking battery, and waiting 5 minutes or so, can hook up battery and unit will idle, then stall out when pedal is depressed at any position. Is there a learning procedure?
Showing items 1 - 1 of 1 results.
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.