Hello everybody!
does anyone know what does it means?
our forklift show the error: 523249-4 but he ride normal, then he show another error 2236-12 and all joystic can work how they want.
Restarting the mashine solve the problem, but 1 hour later the problem starting from the begining.
Please if someone have service manuals with error send it to me.
or write me here how to solve the problem
Regards!
Showing items 1 - 7 of 7 results.
Hello eweryone
I can help you please add me on skype: hyster.brasil
Hello eweryone!
Does anyone have the calibration manual with number "ELECTRICAL SYSTEM 2200 SRM 1142"
Thank you very much
Is it posible that forklift wont run
DTC 524238-3 - Rear Wiper Motor Driver OORH
Diagnostic Trouble Codes Electrical System
524234078-3
TSP Drive Command Signal OORH
CODES
DTC 524237-3 - Front Wiper Motor Driver OORH
DTC 524238-3 - Rear Wiper Motor Driver OORH
DTC 524240-3 - Washer Pump Driver OORH
POSSIBLE CAUSE
A. WIPER ARM STUCK OUT OF PARK POSITION (OBSTRUCTED) (DTC 524237 OR 524238 ONLY)
B. PARK SWITCH SHORTED (DTC 524237 OR 524238 ONLY)
C. MOTOR/PUMP DRIVER OUTPUT SHORTED TO BATTERY
D. MOTOR/PUMP DRIVER OUTPUT OPEN CIRCUIT
E. MOTOR/PUMP DRIVER RETURN OPEN CIRCUIT
F. MOTOR/PUMP/FUNCTIONAL FAILURE IN CONTROLLER
Hello!
I have a Hyster forklift h2.0ft with a error code 524238-3
serial numer is L177B26430F
Can you help me ?
Thank you Robb and peter!
DTC 523249-4 - Lever 4 Position OORL
POSSIBLE CAUSE
A. MINI LEVER FAILURE (GENERATION 1)
B. MINI LEVER MODULE (MLM) FAILURE
C. FUNCTIONAL FAILURE IN CONTROLLER
DTC 2236-12 - CANbus Comm Error With MLM
POSSIBLE CAUSE
A. TERMINATION RESISTOR(S) OPEN CIRCUIT
B. OPEN/INTERMITTENT CIRCUIT ON CAN HI, CAN LO
C. CAN HI AND CAN LO SHORTED TOGETHER
D. OPEN CIRCUIT ON POWER/GROUND TO CAN CONNECTED DEVICES
E. STG ON CAN HI
F. STS/STB ON CAN LO
G. CAN CONNECTED DEVICE FAILURE
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.