Driving problem, something is stoping drive - Technical Troubleshooting discussion in Forkliftaction's forums

Hyster R1.6 H:
Driving problem, something is stoping drive

Hello everyone,

we have some problem with Hyster R1.6H. Forklift driving but it stops and it's seems like something stoped him.

We have change all bearings in axle, bearing on drive motor sensor bearing. Brake is ok.

Posted 18 Nov 2016 19:12
Discussion started by matej_b
Medimurje, Croatia

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

is there a error code on dash or in error log.
you can remove electric magnetic brake and put on floor where operator feet are while still connected to wiring harness. then jack unit of ground and drive unit to see if at full speed. if not the encoder for drive motor could be u/s. by the way if encoder is fitted wrong by pushing on the out side it will properly no good. it could be the traction controller playing up. swap the hydraulic controller with traction.

Posted 25 Nov 2016 01:51
Reply by redbull
Queensland, Australia

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.