dead batteries - Technical Troubleshooting discussion in Forkliftaction's forums

Crown SERIES M WALKIE LIFT:
dead batteries

I had new batteries installed by Crown in December or January. My guys forgot to plug the stacker in and now the batteries are dead. I tried to put them on trickle charge but nothing. Is there possibly a trick to get these batteries to charge without calling Crown out again?

Posted 7 Jun 2025 12:41
Discussion started by Kevin_Clark
North Carolina, United States

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

are you saying 1 12v battery attached to 2 of the 6volts? and then probably do it again for the other 2 batteries? And wire them in series or parallel?

Posted 10 Jun 2025 04:54
Reply by Kevin_Clark
North Carolina, United States

Post a Reply Report this post

If you have a jump pack, you can place the clips across 2 batteries (12v) and jump it. That should get the voltage high enough for the on-board charger to start.
That all depends on how low the voltage is and if there are any possible dead batteries.

Posted 9 Jun 2025 20:55
Reply by DyslexicNerd_01
Wisconsin, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.