Reach keeps displaying code GD, I've checked the steer encoder, the steer motor. Any ideas on what else it could be?
Showing items 1 - 8 of 8 results.
My experience with code gd besides steer motor encoder is steer gear box going bad, ring gear loose and spinning on drive unit, steer sensor flag, broken teeth on pinion or ring gear. Good luck
Hi, i have multiple errors on display like FN , FH,. Fault in vehicle manager , I have different model vehicle manager but part number same i need a software to install. I have flashware software but i need a package. Thanks
check steer motor gear that the keyway is not sheared on the gear i have had that happen before if not there is a steer module that connects to steer motor possible fault
Hi, could you please help me for installing a new vehicle manager in raymond DDRT32 TT. Thanks in advance
Had the same issue and found the brushes for the motor were worn down very bad and the connatator for the motor was filled with dust from the brushes. Replaced brushes and honed the the connatator. No more issues after that.
Nice day
I have the same error this computer is a 740dr32tt
I see that it has no direction control
Only one contactor energizes the steering dc motor
What is the address controller
Best regards
this can be any loose steering parts. when the encoder sees input with no driver input it will code.
i have had the vehicle manager cause this code a few times but more common play in steer linkage, drive unit bearings, or any loose parts that have to do with steering
I was getting a GD on a Raymond double reach 750 including G4 and 4B. I replaced steering wheel encoder and still problem continued. I finally replaced the steer amplifier and it worked. All codes cleared.
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.