Code 8L - Technical Troubleshooting discussion in Forkliftaction's forums

Raymond 7400:
Code 8L

If you are having an intermittent code 8L make sure to check the wires and the connection where the brake assembly plugs into the units wire harness at the top of the drive motor. The plastic ties are set very tight from the factory and either cut in to the wires or plug the wire from the solderless pin.

Posted 7 Dec 2018 06:51
Discussion started by tyler_d
California, United States

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

Recently had the code 8L but it was not for as broken wire. The brake coil is supposed to OHM out at 9 to 10 OHM's but I had 0. Installed new brake assembly to solve the issue.

Posted 23 Apr 2019 05:50
Reply by tyler_d
California, United States

Post a Reply Report this post

Nice. Thanks for the advice.

Posted 12 Dec 2018 18:11
Reply by LaGrange
Missouri, United States

Strong in mind, Strong in Health.

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.