Any Canadian Techies out There? - Design & Engineering discussion in Forkliftaction's forums

Discussion:
Any Canadian Techies out There?

As a trainer, and definitely not a service tech, I have a tech question for you. From my understanding, and knowledge, all forklifts in Canada, the data plates, must be in the imperial measurement system. Although Canada is a metric country, data plates are supposedly to be in imperial, and if so, metric beside it.

If you were a service tech, and you were performong an annual safety inspection, and the forklift being saftied had a metric only data plate, would you strongly urge the client to switch over to imperial? Would you certify the truck even though it has a metric data plate?

Posted 22 Dec 2008 12:31
Discussion started by dan_m
Ontario, Canada

Constantly Lifting The Standard!

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

www dot ccohs dot ca/oshanswers/safety_haz/forklift/load dot html

the CCOHS (canada's equivalent to OSHA) doesnt specify on its site about units of measure, but its example of a data plate is only in metric
im going to assume its ok as long as the capacity accurately reflects the max rated load
call them and ask im sure the # is on the site

IE: if a 2500 kilo rated machine has a side shifter installed but the plate still reads 2500 kilo then the plate is wrong and i woulnt pass it

Posted 22 Dec 2008 14:45
Modified 22 Dec 2008 14:47 by poster
Reply by justinm
New York, United States

New York, New York its a heluva town..you know that The Bronx is up..and I'm Brooklyn down

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.