AC input on charger - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
AC input on charger

I have a Tennant 2200 36v charger. I need to change input from 408v to 220v 1ph. I moved board inside to 220v.now charger turns on for about 5 seconds then shuts down.The manual was not with charger.There are six nuts holding board in.2 are obvious but not sure about others.I tried several different places. Is there something else I need to switch for 220? Any help would be greatly appreciated.

Posted 27 Feb 2013 12:42
By jim_k
joined 28 Aug'08 - 21 messages
California, United States

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

there is also a jumper that needed to be moved on the control transformer (small, electrically attached to the line contactor's [24v] coil) a/c input line. maybe too late now. more than likely still will work if you fix the wires

Posted 27 Feb 2013 22:04
By edward_t
joined 5 Mar'08 - 2,334 messages
South Carolina, United States

"it's not rocket surgery"

Post a Reply Report this post

Find the dealer or manufacturer and they should send you the configuration free

Posted 27 Feb 2013 20:15
By 7777
joined 8 Mar'11 - 649 messages
New York, United States

thanks for the assistance. JCFORKLIFT@gmail.COM

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.