reach truck mini lever not working - Technical Troubleshooting discussion in Forkliftaction's forums

Hyster R1.6N:
reach truck mini lever not working

fault codes 228-01 and 228-33......NO CAN MSG A..... I swapped the mini lever and tested it on another truck, it works, i did the same to the VCM module and it also works.....i checked the harness between the mini lever and the VCM module for continuity and seems ok..please i am pleading, any help ?.....thanks

Posted 2 Aug 2024 19:15
Modified 2 Aug 2024 21:17 by poster
Discussion started by northstar
accra, Ghana

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

North,

Since the lever and module are good, there is an issue with one of the connections. You will need to remove the wires out of the connector and inspect each crimp. Also look for any corrosion at all connectors. You may be able to read ohms at all connections, but the wire may not be able to carry voltage needed. Good Luck.

Posted 19 Aug 2024 22:35
Reply by Fishmech
Virginia, United States

The hard to do we do right away. The impossible just takes a little longer.

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.