Showing items 1 - 7 of 7 results.
Thank you Sir, much appreciated!
It would either be in the service manual in the electrical section. Otherwise enter the service menu go to calibration and scroll till you find the height switch calibrations. The menu will walk you through what you need to do.
Hi Tommy, thanks for the suggestion. Do you have a lead on how I would find the instructions to do this procedure?
Have you tried recalibration the sensors in the service menu? If it is having trouble figuring out the heights that can solve the issue. Sometimes when the height sensors are not calibrated correctly the weight measurement turns off.
As a novice, hard to see what exactly the transducer looks like. can see a hydraulic connection to the cylinder, but no wires attached there. also noticing that the height gauge goes from nothing to 79" at a raised height of maybe 70" , stays at 79 regardless of how high the forks are raised, but then lowering past the actual 70" mark, the 79 disappears. so both the weight and the height measurements are affected. any other suggestions?
As a novice, hard to see what exactly the transducer looks like. can see a hydraulic connection to the cylinder, but no wires attached there. also noticing that the height gauge goes from nothing to 79" at a raised height of maybe 70" , stays at 79 regardless of how high the forks are raised, but then lowering past the actual 70" mark, the 79 disappears. so both the weight and the height measurements are affected. any other suggestions?
Check the pressure transducer, believe it is on the tilt cylinder. Could be bad or the wires just got skinned by product.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.