Hello,
I have a problem with E16-02, year 2005.
When the forklift is switched on, the red light (M symbol + temperature scale) comes on and the forklift does not have the correct speed. After 5-10 minutes of driving, the light switches off and the forklift operates normally and has a normal speed.
Where could the problem be?
Thanks for the answers.
Showing items 1 - 4 of 4 results.
Hi,I have the same problem the display says 1,is this the left motor as you are seated looking forward and where in the motor is the temp.sensor I have found the brush inspection covers but not sure where the sensor is
Check if warm up all fan turn correct , if they short than motor heat.
Disconnect the 4p connector of pump or drive motor for check all fans turn.
2 wire of the 4p saab connector are the brush indicator and only a red light in dash, normally not drive slow if this error , only overheat motor than drive slow. connect a different temperature sensor for check
Motor temp sender within the motor
On the display I should show a 1,2 or 3 to indicate what motor
Modelo 335 o 386? por lo que veo es 335
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.