Hey guys, I recently pulled the engine out of my Clark C500 (Waukesha D155G) and rebuilt it. I dropped the engine back in the other day (what a nightmare it is getting these engines in and out with those **** motor mounts on the frame).
Anyway, I started barring the engine over to line up the 5 small bolts for the torque converter flex plate and the flex plate is moving with the flywheel. What is going on here? The whole transmission is spinning, I can see the gears that are driven by the output shaft of the torque spinning too. This shouldn't happen... The turbine should move freely should it not??? What am I missing here guys? Need to get those 5 bolts in to mount the flex plate to the flywheel before I even think about firing it up... Drive wheels are off the ground and transmission is in neutral. Everything on the trans side was working fine before I pulled the engine.
Thanks in advance.
Nick
Showing items 1 - 1 of 1 results.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.