Working on a 6BPU15, code 47.
Carriage manager, display board and cable assy that connects the two have been replaced. Code has not cleared. Manual says those components could be the issue. Nothing left to check per the manual.
Anybody had this problem?
Showing items 1 - 6 of 6 results.
Well I have an interesting update.
The cause of the code was a shorted blue safety light lol.
Did you get it figured out? just curious,
I was able to get in, with no change.
I didn't check that though, I will try that! My coworker has the manual and he's off this week. So I appreciate the test numbers to check!
I did test mast cables just to eliminate them, they were good.
Thank you!
Did you get anywhere with Analyzer mode? I was looking in the manual. Maybe test 61 or 51 would help.
61- shows current software installed. (includes display card.)
Example
Access analyze mode
At the anl scroll to 6.
and the run to 1.
There are other test under encoder that might help.
Good luck
Thanks, I'll give that a try.
I would try Analyzer mode. The tuning mode portion also allows communication to Power Amp. See if you can do a factory default. or change parameters.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.