Hi and thanks in advance for any help! I replaced a water pump and when I finished up the lift wouldn't start again. First thing I did was check timing to make sure it was wrong. It was right by the marks and piston on tdc rotor pointing at number 1 plug wire. Feel pretty confident that's it's all correct. Next I check to see if I was getting any spark to the plugs and I didn't. Wiggles wires, check plugs to coil and crank sensor and everything look good. It did start once at this point but only once. Thinking it was a bad wire in the harness I Ohm the wires in harness and everything checked out. Replaced crank sensor and coil and still nothing. Could it be in the exam? Has anyone ran across this?