Showing items 1 - 6 of 6 results.
Was a faulty ECM, thanks all
Mike2000 contact my profile, i may have some helpful info.
jroy500 @ hotmail dot com wiring diagram please
plugs and connectors seem to be ok but I checked continuity from connector to ECM and I have one wire who seem to go at a few place with resistance...is it normal?? I'm about to try with a brend new throtle body..maybe the tps is bad inside
do you have the wiring diagram??? G30P-3 GB-00260
Fault 26 Electronic throttle sticking.
Fault 27 Throttle position sensor value differs from SECM calculation
Fault 28 ETC spring or same as 26.
Above faults are frequently associated with throttle body open wiring
First check the wiring and plugs to and from throttle pedal.
Check for opens or disconnect on throttle body plug area.
Doosan's often have broken wiring where the harness connects to
the throttle body plug. Occasionally when running if the wires are
manipulated engine speed will change indicating an open.
Code 26 27 28 after I try to start
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.