Adjusting plate - Technical Troubleshooting discussion in Forkliftaction's forums

Crown RC5530:
Adjusting plate

Greetings

I dissembled the right drive unit on a crown RC5530, and removed the adjusting plate, that I thing adjusted the drive axle preload????

It is threaded , turns 360 degrees , and has two locking set screws.

What is the proper way to adjust this plate, it is not covered in the coustomer manual.

Thanz

Posted 6 Aug 2016 05:07
Discussion started by harold_c
Maryland, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Are you talking about the wheel hub with the five studs that the wheel bolts to? This has a castellated nut that secures it with two cap screws. The locking nut is torqued to 542 NM (400ftlb). As long as you haven't removed the wheel hub you should be ok as it needs to be heated to 200 degrees C (400f) before fitment and the nut immediately fitted to the correct torque.

Posted 15 Aug 2016 10:26
Reply by techno_nz
Canterbury, New Zealand

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.