Hi there,
Need emergency help !
changed master cylinder and put new brake pads & wheel
cyl, tried bleeding it, but the brake pedal still go goes to floor won't hold pressure, what can I do ?
mrosupply
Showing items 1 - 3 of 3 results.
This is and older posting, did you get and answer, if not have you look at inching valve on the Transmisssion.
If the shoe adjustment doesn't do the trick, Make sure parking brake is off and try bleeding the system backwards with Mighty Vac. (Thus pushing the brake fluid up from the Wheel cylinder to the Master cylinder).
How's the brake shoe adjustment? When I do a brake job I always set the adjustment a little on the tight side so bleeding is easier & the brake shoes will wear in faster.
I adjust the brakes so that- at an idle in gear- wheels off the floor- the drive tires won't turn unless the gas pedal is slightly depressed.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.