Showing items 1 - 15 of 15 results.
Found error codes on BT
https://www.truck-freeworkshop.com/bt/bt-fault-codes/
C26 = Input stage error.
Check the error log as it will pinpoint which input it is with a logged code but I would suspect a hydraulic joystick isn't in the neutral position at start up - normally a bic biro is the cause.
Need help!!!
Any idea on the error codes C26 on start up?
Thank you
Will do. Just to let you know, I wrapped the path to the template file in normalizePath and now it works perfectly. So it does seem that the path was the problem. On a related note, I had the same issue with addImage() and I used normalizePath there too. I mention this in case this issue shows up other places.
mostly is spring in brake pedal broken.The pedal give in neutral a higher voltage to a5 board than it is calibrate before starting with drive then it generate a fault. you can fix it easy.If you have again the error you need calibrate the pedals. You need truck program or cankey
Mhonotone you said you have fixed the fault,
what did you do to repair C16 C17 on pedal press.
A5 card internal battery low voltage.
Any ideas on c018?? BT rrb2
C028 = Emergency stop switch activated.
Or the emergency stop circuit has detected a fault.
Hi
I need a little help. BT machine is throwing an error code C028.
Can anyone tell me what this error code is.
Thanks
I've already fix it... without cankey. i was just needed the info about the error codes because i dont have the service manual of this machine ;/
Thanks a lot again!
Are these codes happening at start up OR when the truck is being driven?
Also check the spring under the brake pedal as these do snap after a while allowing the brake pedal to go out of calibration.
Thank you nacsand_n! I appreciate your help. (bow).
No, this codes are not the service reminder.
C16 indicates accelerator potentiometer voltage is out of range
C17 brake potentiomer voltage out of range.
Make sure both pedals are not actuated on start up the truck, but I think you need to do a brake and accelerator potentiomer calibration through parameter nº38, but will need the service CANKEY
Regards
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.