Hi
I am replacing a ring gear on a Linde H30T03 351 series.year 1998
Does the engine seperate between the bellhousing and the adaptor plate on the rear of the engine OR between the bellhousing and the round adaptor going to the hydraulic pump.
Is there a splined shaft in there? I cannot locate any bolts in the bellhousing that would secure the flywheel/driveplate in the bellhousing.
Is there any hints you may have for this procedure.
This is one of the few Lindes I have worked on and they seem to like to do things a bit differently that most of the other manufacturers out there
I am guessing it is about an 8 hour job to do.
Thanks in advance for any information you may have.
Steve
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.