Locked up motor , torque converter stuck in trans , what have I broken - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
Locked up motor , torque converter stuck in trans , what have I broken

I picked up a Clark GPS30 , the motor is locked up , so therefore I could not unbolt the torque converter from the flywheel, Well after lots of prying the converter is out , there is a gear on the end of it , that looks like it was driving a chain. I have seen a broken bearing cage , roller bearing , not ball bearing. and took the seal out too.What have I done , I was thinking it would be like a car , and the converter would just slide out , but no. Do I have to remove the trans to fix it ?

Thanks Daniel Cross

Posted 16 May 2022 13:42
By Daniel_Cross
joined 6 Nov'20 - 8 messages
Virginia, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Yes, you will end up pulling the transaxle assy. All comes out the front. Mast off. Be aware, with mast off and trans/diff assembly out, the truck will tip back. The counterweight will need supported. I recommend getting the service manual for that machine. It breaks down the specific trans. Or at least get the parts breakdowns. That should be the HR600 Transmission.

Posted 19 May 2022 05:00
By ErichO
joined 26 Oct'21 - 83 messages
Washington, United States

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.