Telescopic cylinder - Technical Troubleshooting discussion in Forkliftaction's forums

JLG 40HA:
Telescopic cylinder

Rebuilding the telescopic cylinder on a JLG 40HA. At the rod end, the rod seal does not fill up the groove. It could "travel" back n forth approximately 1/8". I've never seen a seal that it suppose to go back n forth. Should there be a spacer ring to take up that space? The old one had disintegrated and wasn't anything left of it. Planning on calling JLG tomorrow. Any help would be appreciated. Thanks in advance.

Posted 3 Dec 2024 11:50
Discussion started by MarkSchrack
Pennsylvania, United States

Mark

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.