Hello!

Thanks for the input. I think the steering motor is good since the fuse F3 is Ok and when I turn the steering wheel it starts spinning and then stops. So think it is ok. it does not give a error code when it turns/stops.

On the following link you will find a photo of the motor and sensor signals:
https://meocloud.pt/link/aec8cc1b-cd1f-4f34-bc56-6134ac08b291/Partilha/

When I press the joysticks and pump motor starts it poops up the error E0. I have measured the output signals of the encoder bearing and for me, they are odd. I think we should have two output signals and V+ and V-, but I have there three signals on the output!

The bearing as been changed, not by me, and the motor started working linear but slowly. Before that it was slugging when I press the joystick. I have changed the drives and still the same result.

Also the motor cables are warm after some time.

Could it be the problem is the motor itself?

Thanks and bear with me since I am new to forklift repair.