Hey gang
I had this machine brought to check out and the Spectrum LP regulator was frozen (a new symptom) and leaking as it was being unloaded. I ordered a repair kit. As I was installing it today I found that the arm that attaches to the secondary regulator valve is actually a little higher than the regulator housing. The instructions said 1/32 clearance and I assume the want it slightly lower than the housing like a model J would be. It also stated the regulator would need to be replaced if not in spec. Any ideas on this??
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.