T50D/8EB3051.Yes I think 85,now.Im not positive,about pin.Ive had this lift about a year.For sell.It had set along time,a couple valves had siezed up in the guides.pulled head done valve job,alls good.used it around the shop for about a year.A customer used it for about a week.It started sliping in forward,But after restart.Forward was ok again.The next morning,forward was out again.I checked voltage from switch ,down to connections going into SAM valve.Then removed cover to sam valve solnoids,both where working.I removed forward valve.dissembled it.Didnt find anything.Switched forward and rev. solnoids. slid forward valve back in place.Did not remove rev valve.[as it was working fine]. ,Screwd holding pins back down into valve body on top of trans.Now Its in rev. all the time.After shifting to rev.It doesnt come out. I can see both solnoids working[.running it, With cover off].I have removed wires from SAM valve.And tried pushing each in by hand.It stays in rev.Untill engine is restarted. So,Edward Im not sure if pin is in exact postion.What pin are you refuring to? Thanks for help Kent.